October 6, 2024

dent

Steam can reverse dent injury in wooden household furniture

Q: My kids had been playing all-around in the dwelling and a tennis racket strike the leg of our coffee table. In any case, the racket dented the wooden leg and it is really visible. Is there everything I can do?

A: The initial factor I would do is set some floor regulations. Possibly you can make the spot from the espresso desk to the couch out-of-bounds, and if the ball bounces off the wall, it is a issue for the other player. It’s your get in touch with, but you might check out Wimbledon rules.

The dent you describe is caused by an influence that compresses the fibers of the wooden. It can be reversed again to regular with the aid of a small steam.

Just place a handful of levels of moist material over the dent and then touch the cloth (not the bordering wooden) rapidly with a hot iron right up until you get the ideal end result. Be informed that this course of action can go wrong really rapid, so you have to have only contact the cloth and carry it off rapidly and steadily extend the get hold of time until the dented area is degree with the bordering floor. Then allow the location dry.

This system performs effectively on good-wood home furnishings, specially unfinished home furniture. If the piece makes use of veneer (a slim layer of wood that is glued to a much less expensive area), never use the iron to it as it will soften the glue that retains it down.

The moment the space is dry, lightly sand it or the area may take in far more stain and transform a a little bit darker color than the encompassing location.

If the affect was strong sufficient to slash the wood fibers, the steam trick won’t get the job done. In that scenario, you will need to have to fill the location with wooden putty to make it degree, and then stain it to match the surrounding spot. If the finish is not cracked or damaged, and only the wood is compressed, you can attempt alternating hot and chilly to the place.

Normally, you will will need somewhere amongst 100-120 levels for the warmth and some ice for the cold.

Lay dry material on the ruined area and use the heat for 10-15 minutes and take away it. Then location some crushed ice in a baggie and set it on the wood for the similar time. You can repeat this approach numerous situations and the compression will generally increase back again up.

If this procedure fails, you could be faced with both scraping the complete off and employing the steam trick. But then you will have to refinish the region.

You just might reconsider the total deal if restoring the piece of household furniture is past your comfort and ease stage. Just tell your guests that the dings and scratches give it character.

Mike Klimek is a certified contractor and proprietor of Las Vegas Handyman. Inquiries could be despatched by electronic mail to [email protected]. Or, mail to 4710 W. Dewey Generate, No. 100, Las Vegas, NV 89118. His internet tackle is www.handymanoflasvegas.com.